- first in here too
- ideas wanted
- So, lets talk frame mounted pivots
- Square tubing Driveshaft?
- for mister and his wanted ideas
- Hmmm uhh guys?
- Divorced tracker case
- muddmachine re:1.3/1.6
- custom drivesaft
- Spring saver
- pinion flange
- not promoting this but
- Got brake ???
- Subaru birfs??
- Toy rear diff conversion - depot style
- Emergency stop switch
- 1.6 8V engine swap
- where can i get oxyegen and acetlyne tanks filled?
- extending wheelbase question?
- the crusher
- It has Started
- Metal lathe access...
- MuddMachine a welding Question
- pipe bender
- shackles???
- 4 door sidekick SAS swap.
- EFI Fuel pump question
- sas tracker
- cage question?
- Grasshoppers legs.
- Pics of sammy rear springs put on front
- 4.16 t-case build
- Check out this Shaffer dude's rig
- Toyota help
- motor mounts
- 1.3 16v swap
- COILS! Finally no more poser shots!
- 1.6 engine + trans/tcase + sami case
- Hmmmmm
- stretching sami body
- welding question
- lincoln lockers
- It's ALIVE!!!!!!!!!!!!!!
- Fullloads build
- Trac Bar
- Toy rear disk conversion - Depot style
- Weld-on bead lock rings - installed
- Scotty has built it up.....again!!
- Lets see some custom bumpers
- WARNING!!! Custom offset rims....
- Kicker 3 from OTT
- Almost stock SJ410
- Pipe vs Dom (yes again)
- Cage, do you have one? If not...why?
- Almost there
- Toy's on a kick
- crusier axles
- Can you Turbo your 1.3l??
- flat top pistons....
- idea's anyone
- Toy ps 2wd or 4wd ifs box?
- Pony Carb Question
- Toyota/Suzuki dual transfer case
- made these last night
- 1.3 auto
- after the roll over
- Its not a Zook but....
- HELP!!!!!!!!!!!!!!!!!!!!!!!
- LJ motor Mods
- Toy power steering
- 4.3L is out, 1.6 going in
- rear axle from a 2wd tracker
- Welded Front and Rear
- Samurai Flatdeck
- pumpkin bashing
- Bitten by the coil bug
- Reccommendations for leafs/shocks
- New MIG wire on the market.
- sidekick lift question
- Sidekick Lift-is it possible to.....
- sammy t-case modification....
- Roll cage questions
- 4.3 with Toy. trans/t-case?
- Deepmud's one-link
- sooo can u
- Tube chassis designs?
- When AUtoCAD meets the trail
- SIDEKICK & TOYOTA, MATCH MADE IN HELL
- Samurai with half-tracks? Not quite...
- Intermediate Reduction box
- Anyone using a saginaw pump?
- Power Steering
- Toyota axels on my 88 1/2?
- 1.3 to 1.6 adapter plate
- Diff Armour
- Aluminum Dash
- Here we go Again
- CV joint Q.
- Sammi t-case in Kick/Track
- Front driveshaft vibration
- yet another dual t'case buildup
- A little upgrade for the Diesel Sammy
- YJ leaf set up on a sami
- warn 5687 winch bumper
- DUAL SLIP YOKE DRIVESHAFT-stretchx2
- D30 under a sammi
- has the forum name changed??
- bumper I cooked up tonight
- Toy steering arms.
- dual caes in a sami
- some side protection
- could it be? YES anouther dual case setup!
- CHEAP On board Air. & 4AIR System Inflate & Deflate 4 tires
- GOT TWIST!!!
- Spring perches and springs?
- Safari Rack
- Modified tranny tunnel
- Flanders under the knife
- Diff welding 101
- tough paint for homemade bumpers?
- whats better ?????
- Rings on things
- trussin' the housing
- Dual Stick t-case
- Mudd's butcher work.
- pony carb on 1L?
- ott kicker 3 impressions?
- 2nd t-case beef up
- welded rear-ends?
- Leaf Springs Suck - Going Coils
- more munched gears
- New Stabilizer Bar (avec pics)
- twin sticks
- RPM vs. Gear vs tire size speed calculator for LOW Range
- A little hacking
- Control arm bushings?????
- what do i do with the rear knuckle for an 8 inch suspension lift??? ne ideas
- HELP PLEASE!!!!!
- 12 inch lifted tracker with ifs??? anyone interested???
- 2X kick t-case's
- Ooooops! ....I did it again...
- ecm or ecu capacitor mod???
- Body lift idea's
- Dana 300 2nd T-case
- chev 350 would it fit????
- What driveline to put behind a 16V motor??
- What do you think...
- Toyota axles with high steer and lift springs - will it work?
- no turning back now......
- golf cart buildup
- Project SamiFlyer
- EFI Gas tank in non-EFI sammy
- power steering question
- A few changes: SJ410 Buggy
- hacky hacky...... good bye body
- Getting custom cut t-case gears.
- DANA300 2nd T-CASE FABBED IN
- New tires?
- What's Zukin up to...
- Hydro assist on toy diffs (ram setup)
- Hydro assist on toy diffs (box porting)
- Looky what I got
- Airbag suspension
- Where to buy a digital level?
- Cheap manual line locks..
- Hydro Steer and Priness Auto
- Stick Welder Question
- grand theft zook!!!!!
- Yard sale winch In my buggy. $150
- twin stick 205
- on board air
- Full Hydro bridge problem
- What do ya'll think
- dana 300 dual transfer case (a better look)
- Project Big Block Sami
- Got steering???
- 84 t-case
- retubing a HP Dana 44
- Some recent work to the buggy....
- rebuilding a Ford 9"
- Another 9" rebuild...............take 2!
- making drive shafts
- thoughts on this build
- VW Diesel in Zook....idea
- Pipe VS Tube Tech
- I have defiled myself....
- twin fuel tanks
- How CTIS works.
- Drop Links?
- Custom Bumpers
- MLC's 06 build
- BootyFab bushing mounts!
- toy steering swap
- Zukin's new mods
- N.S. Punk's build
- 3 link formulas
- Pics of my buggy
- project "WideLoad" :)
- To do or not to do?
- GOT TWIST X2
- hi steer done
- 0% approach with leafs?!
- 2dr side kick + cj axles + dual t-cases = ???
- Extended shock towers
- TRE links ?????
- Caculating 3-Link Rear..
- front driveshaft bind ?
- DIY Flare Extensions
- Version 9.0 ( Final Act)
- My Junk
- Got a new toy!
- GroundHawg or SammyHawg
- rear steer?
- Zukin's toy (pics)
- Questions about tapping tube
- Travel of steering RAM for Toy axle
- Non-Zook Booty fab Sarg style
- Dual Kick t-case setup?? Info out there?
- Spring Perches
- I want this!!!
- project "bigzook69" anyone wannsee whuts up!!
- see my new bumper!!!
- Kick t-case to D300
- D300 in a Kick, plan B.
- Axle Strength
- What am I doin now ???
- Leafs as Radius arms w/coils. Hmmm....
- proper coil springs
- Steel Supplier
- shock hoop recommendations
- a freinds junk
- project "slinkysdisco",rebirth of a stock zuk!!
- KAC's winter build 07
- 350 chevy motor transplant
- Family Crawler
- My dana 300 to kick case...
- tracker bumper
- sas'ing the "lurch"..soldifying the tracker..
- tracker sas
- ANyone fab up theier own YJ spring to samurai moutns?
- Project "Not so Extreme"
- Zook friendly machine shop in Ottawa sought ..
- full hydro
- Waterproofing electronics .. (ECM)
- cutting T case
- Disc brakes on sidekick rear axle
- truggy build for myself
- Lengthening Driveshafts
- rocker/rock rails
- Time to go bigger