transfer case mounts

[drtysuzuk]

went down to Lingham on Saturday...... played on some rocks and managed to submerge the wifes side about 8" above the seat....the deep holes always seem to be on that side of the truck...go figure....anyhow while on the rocks i managed to break another rubber mount.... i,ve tried useing urethane and thru-bolting with no luck so back to suzuki...is there a better way?

drtysuzuk:po:

[Fullload]

Are you running a 4.16 t-case???

[Depot]

bombproof t-case mounts are da shiat but for thsose of us too cheap to fork up the 20 bucks for a set of 3 (USD) heres another proven option...

4 inch bolts.. 1/2 inch diameter... drill out arms and moutns to accpet bolt.. use 3 sidekick bodymounts for each t-case mount (with the steel cover for the outside 2)

put bolt/steel case/rubber/t-case mount arm /rubber/frame mount/rubber/steel case/nut.

this tri-design gives u compression and limited expansion.. worked great 4 me soo far cept now im ripping the mounts off the frame itself.

if u dont have kick body mnounts... use some thicker rubber or poly mount.. kick ones are nice cause theres lots around, they're an inch thick and squish real nice.

depot

[xfaktor]

HD t-case mount: TRW 18060
This is a link kit for ? car
Use the ruber to make a HD t-case mount.
Cost about 3$each at my price at my job.

[off_your_rocker]

3/8 bolt and 3 squares of 1/2 inch rubber conveyour?? belt that you can find any where. ran it for years. two weeks my zook will be done then we can go out again. suddsey said somthing bout goin up to your camp for some trails?