Fuse panel

[Zuklin]

Went to go fire up the old 83 tintop this morning and it wouldnt fire up. It would turn over but not fire. After a few moments of head scratching i realized that the blower fan and the most, if not all of the dash wasnt working either.

Checked the fuses and it seems that the fuse panel is lookin kinda rough/rusty. I would imagine i could just buy another generic fuse block... anyone have any ideas??

Sorry the picture was taken in the dark so its a bit blury... dont even know if its 'factory'...

THANKS!!!

[vanbdan]

Looka like the factory to me.When i had my sj,i had the same problem,so i wired in covered waterproof fuse holders from canadian Tire.Dont forget to lable them somehow!:rant:

van
:hubba:

[MudRunner]

Just replace it with one of these Had to do it on a buddies Heep Xj.

http://www.dsmiller.com/Images/MBB-501.jpg

You can pick em up at any decent audio shop.


Or if ya wanna get all fancy, you can get these kits from painless wiring there $$$ tho

http://www.inclinedvehicles.com/images/70207-a.jpg

[Zuklin]

I was walking threw PA and lookie what i found... $14.00 and now my truck has GOLD in it... :brows: