gordZuki
December 25th, 2003, 09:52 PM
got all this stuff ready to go
complete steering colum from 89 tracker
rad from 89 tracker
1.6 efi from the same tracker
rear 5.13 axle from the tracker
front 5.13 dif from the tracker
drawings for rear disc brackets thx fullload
100amp alt from a gm bucket
bracket for alt upgrade again thx fullload
complete wiring harness and ecm for the engine
a set of drums from an sj410 to be turned down
a set of front cali's from another 86tintop
so all that stuff is goin into the red biatch
here's what is done so far ... rear axle is stripped of all extra metal and cleaned ... getting it ready to do the disc brake swap
so .... not much huh .... well i gotta pull the tranny and get tabs welded onto them ... then mount the engine ... i'm gonna set up the front dif myself so i need what a soup can or coffee can?? or should i just order an install kit ... was gonna ask depot if he could do my wiring but since i am using the tracker column i should be alright knock on wood ... i also think i am gonna grab a set of 9000's for the corners ... and fullload i'm gonna give u a shout so i can get the other parts .... my question to everyone is am i missing anything??
complete steering colum from 89 tracker
rad from 89 tracker
1.6 efi from the same tracker
rear 5.13 axle from the tracker
front 5.13 dif from the tracker
drawings for rear disc brackets thx fullload
100amp alt from a gm bucket
bracket for alt upgrade again thx fullload
complete wiring harness and ecm for the engine
a set of drums from an sj410 to be turned down
a set of front cali's from another 86tintop
so all that stuff is goin into the red biatch
here's what is done so far ... rear axle is stripped of all extra metal and cleaned ... getting it ready to do the disc brake swap
so .... not much huh .... well i gotta pull the tranny and get tabs welded onto them ... then mount the engine ... i'm gonna set up the front dif myself so i need what a soup can or coffee can?? or should i just order an install kit ... was gonna ask depot if he could do my wiring but since i am using the tracker column i should be alright knock on wood ... i also think i am gonna grab a set of 9000's for the corners ... and fullload i'm gonna give u a shout so i can get the other parts .... my question to everyone is am i missing anything??